Installation; Instruction - Furrion FSRI22LA-SB Manuel D'installation

Installation

The appliance must be installed only by a qualified person in compliance with the
instructions provided.
Please ensure to install this product per manufacturers instructions to avoid harm to
persons, animals or damage property.
Important: The power supply to the appliance must be cut off before any adjustments
or maintenance work is done on it.
This oven can be used with Propane Gas only.
This oven is fitted with a threaded 5/8-18UNF male attachment. For installation use
copper pipe and CSA or UL certified fitting and connectors which comply to USA and
Canadian safety standards.
Ensure when this oven is installed the gas supply pipe cannot contact any moving
parts. Make sure adequate space is available so the supply pipe will not be bent or
damaged after installation.

Instruction

● Build or adjust kitchen cabinets to Fig. A
● Ensure the oven height from the top of the counter
top is 4"
● Cut the oven vent hole in the countertop, (Fig. B)
ensure the rear of the cut out position measures
18" from the front of the cabinets for correct
positioning.
● Install a copper gas supply pipe with a shut off valve
and 5/8-18UNF connection to the upper left rear
corner of the oven cavity.
● From a 12V DC power source run a minimum
16AWG 2-conductor cable or above to the upper
right rear corner of the oven cavity, use a 5A fuse at
the power source for protection.
● Connect the Gas pipe and 12V cable to the oven.
Ensure to connect the wires with the correct
polarity. + = Black, - = White
DC12V +
Micro Micro
DC12V +
Switch 1 Switch 2
140°F Normal Open
Micro Micro
Thermostat Control
Switch 1 Switch 2
140°F Normal Open
Thermostat Control
Lamp
Igniter
Lamp
Igniter
DC12V -
DC12V -
LED
Wiring Diagram - Model with LED
LED
Wiring Diagram - Model with LED
DC12V +
Micro Micro
DC12V +
Switch 1 Switch 2
140°F Normal Open
Micro Micro
Thermostat Control
Switch 1 Switch 2
140°F Normal Open
Thermostat Control
Lamp
Igniter
Lamp
Igniter
DC12V -
Wiring Diagram - Model without LED
DC12V -
Wiring Diagram - Model without LED
Micro
Switch 3
Micro
+12V VIN
Switch 3
+12V OUT
+12V VIN
FAN
LED
+12V OUT
GND IN
FAN
LED
GND IN
LED
LED
Micro
Switch 3
Micro
+12V VIN
Switch 3
+12V OUT
+12V VIN
FAN
LED
+12V OUT
GND IN
FAN
LED
GND IN
10