Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The appliance must be installed only by a qualified person in compliance with the
instructions provided.
Please ensure to install this product per manufacturers instructions to avoid
harm to persons, animals or damage property.
Important: The power supply to the appliance must be cut off before any
adjustments or maintenance work is done on it.
This oven can be used with Propane Gas only.
This oven is fitted with a threaded 5/8-18UNF male attachment. For installation
use copper pipe and CSA or UL certified fitting and connectors which comply to
USA and Canadian safety standards.
Ensure when this oven is installed the gas supply pipe cannot contact any
moving parts. Make sure adequate space is available so the supply pipe will not
be bent or damaged after installation.
Instruction
• Build or adjust kitchen cabinets to Fig. A
• Ensure the oven height from the top of the counter top is 4"
• Ensure there is a ventilation hole in the cabinet for air circulation around the
oven
• Cut the oven vent hole in the countertop, ensure the rear of the cut out
position measures 18" from the front of the cabinets for correct positioning.
• Install a copper gas supply pipe with a shut off valve and 5/8-18UNF
connection to the upper left rear corner of the oven cavity
• From a 12V DC power source run a min 16AWG 2C cable or above to the
upper right rear corner of the oven cavity, use a 5A fuse at the power source
for protection.
• Connect the Gas pipe and 12V cable to the oven. Ensure to connect the wires
with the correct polarity. + = Black, - = White
Installation
11
Publicité
Chapitres
Table des Matières
