Electrical Connection - CASO DESIGN Sound & Cool Mode D'emploi Original

 The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 45 cm around the appliance.
 Do not cover up any openings on the device and do not block these off.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.
 For energy saving reasons please ensure that the
drawers are closed when the appliance is turned on.
 Adjust the adjustable feet, so that the device is placed
even.

12.6 Electrical connection

In order to ensure the safe and trouble-free operation of
the device, the following instructions must be observed for
the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 Do not bend the power cord. Make sure that the power cable is undamaged and has not
been installed under or over hot or sharp surfaces.
 The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or
gangs is prohibited because of the danger of fire that is involved with this.
 This unit is not designed to be installed in an RV or used with an inverter.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician. The manufacturer cannot be made responsible
for damages that are caused by a missing or damaged protective conductor.
Options to connect the power cord
1) Plug the mains plug into a ground socket below the device.
2) Place power cord under carpet, to avoid stumbling over the cord.
3) Slot power cord through the supplied slot for the power cord.
Danger
► The mains plug must be plugged firmly into the connection socket on the bottom of the
device, otherwise there is a risk of fire.
39