Philips VisaPure Advanced SC53 Série Instructions D'utilisation page 20

20
English
Using the Fresh Skin head
The Fresh Skin head program consists of 2 treatment periods of 20
seconds. You can use the Fresh Skin head on dry skin or after
applying cream/oil to your skin.
1 Push the Fresh Skin head onto the connection pin until it locks
into position with a click (Fig. 23).
2 Press the on/off button to switch on the appliance and choose
your preferred setting; speed 1 for vibration and speed 2 for
rotation of the Fresh Skin head.
Note: When you attach a different head, the appliance recognizes
it. You hear 2 beeps and the intensity setting indications flash
alternately (Fig. 24).
3 You can focus on the preferred areas of your face. We advise you
to start on the right cheek. Make three strokes with the Fresh Skin
head from the center of the face towards the ear, covering the
whole cheek (Fig. 25).
4 Continue the treatment on the right side of the forehead. Move
from the center of the forehead towards the temple.
Note: Do not push the head too hard onto the skin to make sure
that the treatment remains comfortable.
5 After 20 seconds, the appliance pauses briefly to let you know that
you can move it to the left side of the face to perform the same
treatment (Fig. 26).
6 When the program is finished, clean the Fresh Skin head with
water and mild soap.
7 Store the Fresh Skin head on the storage palette or keep it
attached to the appliance in the charging stand. To enhance the
cooling effect and extend the cooling time, you can store the Fresh
Skin head in the fridge. You can also run cold water over the head
to cool it down slightly during the treatment. Make sure you dry
the head before you continue the treatment.