Manufacturer; Definitions; Transport - Handling - Storage; Storage Conditions - Dometic T2500 H/HG-LP Instructions De Montage Et De Service

1.0 IDENTIFICATION
The identification plate of the machine is affixed outside
the plate casing (see fig. 1).
1.1

MANUFACTURER

DOMETIC ITALY srl
Via Virgilio, 3
47122 FORLI' - ITALY
P. IVA 00718330400
1.2

DEFINITIONS

In this handbook, three types of "safety graphics" are used
to point out different levels of danger or any other important
information:
DANGER
Draws attention to potentially dangerous situations which
may cause serious personal injury.
CAUTION
Draws attention to potentially dangerous situations which
may cause personal injury or material damage.

IMPORTANT

Draws attention to situations which may cause
malfunctioning or damage to the machine.
1.3

TRANSPORT - HANDLING - STORAGE

1.3.1 STORAGE CONDITIONS

The generator is protected against sudden impact by
suitable packing consisting of cardboard, polystyrene and
a wooden frame support.
The generator should be stored horizontally in a dry and
well-ventilated room.

1.3.2 WEIGHT

Gross weight (including packing):
Mod. 2500 .......................................... Kg
Mod. 4000 .......................................... Kg 114
Mod. 5500 .......................................... Kg 140

1.3.3 OVERALL DIMENSIONS

See figg. 2, 3, 4 :

1.3.4 HANDLING

The packed generator can be handled by normal means of
lifting and transport.
Boxes are fitted with spacers which enable the use of
manual fork-lifts.
Strictly observe the accident prevention precautions and
safety regulations during lifting and transport, and always
use machines with a higher maximum capacity than the load to
be lifted.
2.0

INSTALLATION

62
2.1

AUTHORISED PERSONNEL

The generator shall be installed onto the vehicle (caravan,
motorhome or special vehicle) by authorised personnel
only, namely by skilled technicians or workshops, authorised
directly by DOMETIC ITALY srl
If the installation is carried out by non-authorized technicians
2
2500
A mm 470
B mm 535
C mm 565
D mm 320
E mm 315
F mm 260
G mm 27
H mm --
I mm 65
L mm 65
M mm 225
N mm 36
O mm 535
P mm 27
Q mm 260
X mm 590
Y mm 385
Z mm 335
Air intake area
cm 220
2
DANGER
Model
4000 5500
660 700
740 --
770 --
475 515
355 510
310 --
62 --
-- --
78 --
265 --
130 --
17 --
740 735
62 55
310 370
780 770
540 505
380 550
260