Starting The Pump - Varian Turbo-V 1000 ICE E Série Notice De Mode D'emploi

•
If YES is selected, the pump life span, the high power
start total number, the high power start tries and
number of events (flow meter alarm) shall be reset to
000.
After selecting YES, press the PUMP CURRENT push-
button and the display shows:
R E A D Y F O R
S O F T S T A R T
or
P U M P R E A D Y
S T A R T
and the controller is ready to restart (see paragraph
"Startup").
When PUMP LIFE is reset to 000, the CYCLE number
is also reset to 000.
L O C A L
: P U S H
B U T T O N
NOTE

Starting the Pump

If the forepump and vent device are not operated by the
controller, close the vent valve and switch on the
forepump.
Before starting the pump the cooling mode must be
selected.
H S
With the FRONT panel operation selected, the
REMOTE
inoperative; conversely, the CYCLE NUMBER and
PUMP CURRENT push-buttons are always active,
even when the operating mode selected is REMOTE or
H S
RS 232/422/485.
S O F T
[
Where the sign minus (-) become a square ( • ) when the
pump finish the ramp-up step. The active step is indicated
by a flashing square ( • ).
As the ten steps are fully covered, the pump will reach the
Normal operation. If during the Soft Start mode the power
drawn by the pump exceed 200 W the speed of the pump
is decreased to maintain the maximum power allowable
(200 W).
66
TECHNICAL INFORMATION
NOTE
NOTE
and RS 232/422/485
S T A R T
- - - - - - - -
87-900-951-01 (B)
operations are
O N
- - ]