Installation; Installing The Remote Control; Choose A Location - OERTLI RS400 Notice D'installation, D'utilisation Et D'entretien

AD257
2

Installation

2.1

Installing the remote control

3
12/02/2018 - 300020550-001-03
2.1.1.
Choose a location in a "reference" room representative of the room
temperature to be taken into account if the remote control is used as a
room sensor.
200
Locations in the room that are not recommanded:
Enclosed, exposed to solar radiation, heated by a flue duct, exposed to
cold or hot air currents from air ducts, close to an open fireplace, a heat
source (television), behind a curtain.
8800N036-B
2.1.2.
1. Drill 2 holes with a Ø of 6 mm.
2. Put the plugs in place.
3. Tighten the 2 screws.
4. Connect either a 2-wire telephone cable or an electrical cable with
a cross-section of up to 2x1.5 mm² to the 2-pin connector. The wires
can be interchanged.
4
A000850-B
5. Installing the remote control.
5
A000854-A

Choose a location

Installing the remote control
2. Installation
EN
33