Fitting
Instructions
MATERIALS
A
1
Tubular Mainframe with European facing to 94/20/EC A50-1
D
4
M12 x 30 x 1.75mm Bolts, Lock Washers
E
1
Left Hand Side Arm
F
1
Right Hand Side Arm
G
4
M12 x 30 x 1.75mm Bolts, Nuts and Lock Washers
H
4
Spreader Plates
I
1
ZEP35 Electrical plate (not shown)
CB
2
M16 x 50 x 2.0mm Coupling Bolts, Nuts and Lock Washers
FITTING
1.
Remove rear exhaust hanger rubber. Insert Spreader Plates (H) into chassis through access holes on under
side of chassis and loosely attach Side Arms (E) and (F) to Spreader Plates (H) using Bolts (D). Note: Forward
Spreader Plate (H) on right hand side can be difficult to position due to limited access.
2.
Loosely attach Mainframe (A) to Side Arms (E) and (F) using Bolts (G).
3.
Tighten all bolts. Re-fit exhaust hanger rubber.
NOTES: This towbar must be used with either a Witter Towball (part number Z1) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm , M14 - 150 Nm, M16 - 214 Nm
W0001F83A-FIT$0108022200000Ä
W0001F83A-FIT$010802220000
TOWBAR
For FORD FOCUS ESTATE
F83A