Bimar CPH-09 Mode D'emploi page 12

 Do not use the appliance with a timer or a programmer or with a system that
can switch on the appliance automatically, to avoid risk of fire, since a fire risk
exists if the heater is covered or positioned incorrectly. Check that no other high
 Do not use the heater in places where it could be subject to shocks in the
absorption appliances are connected to the same power source.
immediate vicinity of a bathtub, shower or swimming pool
 After removing the packing materials, check the integrity of the heater; if you are unsure, do not
INSTALLATION
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they are potential sources of
 Before connecting the appliance, check that the voltage shown on the data plate matches that of
danger.
your electricity. In the event of incompatibility between the electric outlet and the plug of the
heater, have the outlet replaced with another more suitable type by professionally qualified
personnel, who will make sure that the section of the wires of the outlet is appropriate for the
absorbed power of the heater. Check that the mains are not connected equipment; high absorption
to prevent overloading and fire risks. Check that the mains are not connected equipment; high
absorption to prevent overloading and fire risks. In general, the use of adapters or extension cords
is not recommended; if their use is indispensable, they must conform to existing safety standards
and their current capacity (amperes) must not be less that the maximum of the heater.Attention:
 The appliance can be used when attached to the wall (in fixed position), the surface must be flat,
before use the appliance remove the detachable coupon.
without bumps, very stable and resistant to heat (Do not place or pull the panel on the floor) or used
 Position the appliance far from other sources of heat, inflammable materials (curtains, carpets,
on the floor through the food supplied.
etc.), inflammable gases or explosive materials (spray cans) and from materials that can deform on
exposure to heat. Make sure that there is 100 cm of free space in front of the appliance and 50 cm
 Do not use the heater in places where it could be subject to shocks in the immediate vicinity of a
on the sides.
bathtub, shower or swimming pool to avoid drops of water falling on the heater or the heater falling
in the water: If the appliance should accidentally get wet or be submerged in water, remove the
plug from the supply socket immediately and dry the unit carefully. Check that no liquid has gone
 The heater should be installed 20cm to 100cm from the floor for best performance.
inside and if in doubt, contact professionally qualified personnel.
 Kit wall mounted (included inside the box): 1 x Drill Bit (8mm), 4 x Plastic Mounting Lugs, 4 x
 If the appliance is fitted to a wall, the same must be made of masonry and/ or of heat-resistant
Fastening Bolts, 4 x Caps for Bolts.
material (not of wood or synthetic material which rapidly heats up), care should be taken not to fit
panels where water pipes or electrical wiring might be embedded in the walls; follow the
indications below for installation:
- Use the holes provided in the carton/polystyrene packaging for make two holes in wall 73,6cm.
 Warning: don't use wet hand touch the working machine and don't cover the wind outlet and inlet.
apart, perfectly horizontal; insert plastic mounting lugs, fastening bolts and the caps.
 Before each use, verify that the heater is in good condition and that the electrical cord is not
damaged: in the case of doubt, ask for professionally qualified help.
12/40