HEIDENHAIN QUADRA-CHEK ND 1100 Guide D'installation page 13

ND 1100 QUADRA-CHEK
Installation Instructions
Operating Instructions available at www.heidenhain.de
5. Mounting
The following items are included with the product:
• Power cord
• Stand or mounting adapter
• ND 1100 QUADRA-CHEK Installation Instructions
The following accessories are available for this product:
• Foot switch, ID 681041-01
• Remote keypad, ID 681043-01
• Stand, ID 382892-02
• Mounting adapter, ID 682419-01
Refer to " Accessories and connector pin assignments" on page 116 for additional
information. Refer to the instructions provided with an accessory for additional
information.
Do not mount in a position that makes it difficult to access the power switch or
power cable.
The ND 110x QUADRA-CHEK can be used as a tabletop unit when placed on the provided
stand. The readout can then be tilted forward or backward by up to 20° for the best
reading angle. The ND 110x QUADRA-CHEK is secured to the swivel slots of the stand by
a shoulder screw (5), a cap screw (1) and washers (2,
To attach the stand:
Attach the unit to the stand as shown at the right.
X X
Partially tighten the cap and shoulder screws.
X X
Adjust the unit to the desired tilt position.
X X
Completely tighten the cap and shoulder screws.
X X
Benchtop location and mounting
Rest the unit on a flat, stable surface or bolt the unit to a stable surface from the bottom
with four M5 screws using the hole pattern shown in "Dimensions" on page 115
3 & 4).
4
1
3
2
Stand assembly
5
13