Ayce 0102B Mode D'emploi page 19

FUNTION OF THE MOTION SENSOR
The motion sensor detects movements due to thermal radiation.
The projector is controlled automatically by the motion detector.
The orientation of the motion detector can be adjusted to 40° horizontally and vertically to 50 °.
The delay time can be set between 5 and 360 seconds by using the timer switch (TIME).
The motion detector is both daylight and darkness in operation. Through the lighting control (LUX),
it works under various brightness conditions, if the sensor is switched on.
The brightness you can choose between approx. 3 LUX (dark) and approx. 1000 LUX (light) set.
Set via the control SENS is the light sensitivity. The controller is SENS by (-) to (+) shot, increases
the sensitivity.
Note: Pay attention to the direction of movement. Lateral movements are detected, front movements
are not detected. (Fig. 2)
Note: The projector with motion detector must be fixed firmly. The vibrations have the same effect
as the thermal radiation and affect the normal operation of the detector.
Installation:
Note: This appliance is only intended for fixed installation. Follow the instructions in fig. 3.
Do not install this unit to the ceiling. Do not attach to a Stud. Do not attach to a surface subject
to vibrations. The halogen bulb in the housing would burn out prematurely if the housing installed
at an angle more than 4° .
Fig. 1
Fig. 2
19 | 21
GB
Fig. 3