Cleaning And Storage - Maxx-world Z 07388 Mode D'emploi

EN
0
1
P
2
8. When you want to switch off the device, move the speed setting switch to the 0 posi-
tion and pull the mains plug out of the plug socket.
9. Twist the mixing container anticlockwise and remove it.
10. To remove your food, take the lid off the mixing container by turning it anticlockwise
and removing it from the mixing container.
11. Remove the insert by pulling it out of the mixing container.
12. Finally remove your food.
13. Clean the device and all accessories after each use in the manner described in the
"Cleaning and Storage" chapter.

Cleaning and Storage

CAUTION!
• Switch the device off and pull the mains plug out of the plug socket!
• The blades are sharp; be careful when handling the blade attachment!
• Never immerse the motor unit, cable or plug in water or other liquids! Ensure that the
motor unit, cable, or plug do not fall into water or become wet.
• Thoroughly clean the mixing container, the inserts and the lid immediately after each
use to prevent the formation of germs. Do not allow any food residues to dry on.
• The motor unit is not suitable for being cleaned in the dishwasher!
• Do not use any caustic or abrasive cleaning agents for cleaning. These can damage
the surface.
• Clean the mixing containers, the lid, the stirring insert and the 6-blade insert with
clear, warm water and a little mild detergent or in the dishwasher.
18
2. Place the mixing container onto the motor unit and lock it
into place by turning it clockwise until it engages.
3. Select an insert and insert it into the mixing container.
4. Fill the mixing container with food which you want to chop
up, purée or blend.
5. Place the lid on the mixing container and lock it into place
by turning it clockwise until it engages.
6. Insert the mains plug into a properly installed mains socket
that is easily accessible.
7. To switch on the device, select a speed setting using the
speed setting switch:
P Pulse function for processing in short intervals
To utilise the pulse function: Hold the switch in the
P position and release it when you want to stop
processing. The switch automatically fl ips back to
position 0.
0 Stand-by
1 Low speed setting
2 High speed setting