Yakima Tongue Extender Mode D'emploi page 3

Fasten extension to standard tongue.
Insert bolts through holes and
tighten to fasten the tongue
extension to the standard tongue.
Tighten down the bolts completely.
Insert wire and extended tongue.
Guide the connector through the short tube attached to the
trailer. Insert the tongue extension fully into the trailer.
Secure tongue.
• Insert the main pin through the tongue.
• Secure the main pin by inserting the
safety pin as shown.
• With extension fully inserted close lever, and lock it.
1033553B-3/6
Note: Because the electrical wire runs
through the tubing you may have to wiggle
the bolt as you insert it through the holes to
avoid getting hung up on the electrical wire.
Connect the electrical wire.
Plug the electrical
wire into the electrical
receptor on your trailer.
Test your lights. Be sure your
lights are functioning properly
before driving away.