To start the programme, press
4.
The display will guide you through
a
the programme.
Empty and insert the drip tray.
5.
If there is a water filter, remove it.
6.
Press
.
7.
Empty the water tank and fill with
8.
lukewarm water up to the "0.5 l calc"
mark.
Dissolve one Siemens descaling tab-
9.
let in the water tank and press
Place a container with a capacity of
10.
1 l under the outlet system.
Place the end of the suction pipe in
11.
the container and press
The descaling programme will run
a
for approx. 20 minutes.
If "Refill descaler." is shown on the
12.
display, add more descaling solution
and press
.
Rinse the water tank.
13.
Press
.
14.
If there is a water filter, insert the wa-
15.
ter filter.
→ "Insert water filter", Page 22
Press
.
16.
Fill the tank with fresh water up to
17.
the "max" mark.
Press
.
18.
The descaling programme takes ap-
a
prox. 1 minute and rinses the appli-
ance.
Empty and insert the drip tray.
19.
Thoroughly clean the suction pipe of
20.
the milk system.
The program has ended and the ap-
a
pliance is ready for operation.
Using the cleaning programme
Run the cleaning programme when
your appliance prompts you. The pro-
cess takes approx. 9 minutes.
Requirement: The brewing unit is
cleaned.
→ "Cleaning brewing unit", Page 27
.
1.
2.
3.
4.
a
5.
6.
.
7.
8.
.
9.
a
10.
a
Using calc'nClean
You can combine the cleaning and de-
scaling programmes using the
calc'nClean service programme. Run
the calc'nClean programme when your
appliance prompts you. The process
takes approx. 43 minutes.
Requirement: The brewing unit is
cleaned.
→ "Cleaning brewing unit", Page 27
1.
2.
3.
4.
a
5.
6.
7.
Cleaning and maintenance en
Press
.
Use
and
and care" and press
Use
and
and press
.
To start the programme, press
The display will guide you through
the programme.
Empty and insert the drip tray.
Open the ground coffee compart-
ment.
Place one Siemens cleaning tablet
into the ground coffee compartment.
Close the ground coffee compart-
ment and press
Place a container with a capacity of
1 l under the outlet system and
press
.
The cleaning programme takes ap-
prox. 7 minutes.
Empty and insert the drip tray.
The program has ended and the ap-
pliance is ready for operation.
Press
.
Use
and
and care" and press
Use
and
"calc'nClean" and press
To start the programme, press
The display will guide you through
the programme.
Empty and insert the drip tray.
If there is a water filter, remove it.
Press
.
to select "Cleaning
.
to select "Clean"
.
to select "Cleaning
.
to select
.
.
.
29