Notifications On The Display Panel - Siemens TP5 Série Notice D'utilisation

en Rectifying faults
Errors
Appliance is not dispensing
hot water.
Appliance is not dispensing
drinks.
There is dripping water on the
inner floor of the appliance.
Brewing unit cannot be re-
moved.
Appliance cannot be oper-
ated.
Change displays.
Grinder won't start.

Notifications on the display panel

Errors
Display shows "Close" despite
the fact that the door is
closed.
Display shows "Please empty
drip tray and reinsert." despite
the fact that the drip tray is
empty.
Display shows "Please refill
water tank" despite the fact
that the water tank is full.
32
Cause
Milk system is soiled.
Air is in the water filter.
Drip tray was removed too
soon.
Brewing unit is not in the re-
moval position (e.g. frost pro-
tection activated).
Appliance is in demo mode.
Appliance is too hot.
Cause
Door is not properly closed.
Appliance is too hot.
Appliance is switched off and
does not detect emptying.
Drip tray is soiled.
Water tank is wrongly inser-
ted.
Carbonated water is in the wa-
ter tank.
Float is stuck in the water
tank.
Troubleshooting
▶
Clean the milk system in the dish-
washer.
→ "Cleaning the milk system",
Page 26
Immerse the water filter in water with
1.
the opening facing upwards until no
more air bubbles escape.
Reinsert the filter.
2.
→ "Insert water filter", Page 22
▶
Firmly press the water filter straight
down into the tank connection.
▶ Wait a few seconds after the last
drink was dispensed before removing
the drip tray.
▶
Switch the appliance back on.
▶
To deactivate demo mode, press and
hold for at least 5 seconds.
▶
Wait 1 hour so the appliance can cool
down.
Troubleshooting
▶
Press the door firmly shut.
▶
Wait 1 hour so the appliance can cool
down.
Switch the appliance on, and remove
1.
the drip tray.
Re-insert the drip tray.
2.
▶ Clean the drip tray thoroughly.
▶ Insert the water tank correctly.
▶
Fill the water tank with fresh tap wa-
ter.
Remove the water tank.
1.
Clean the water tank thoroughly.
2.