Astralpool 46888A Manuel D'installation page 9

RECIRCULATE
In this position, the selector valve allows the water from the pump to
go directly to the swimming pool without passing through the inside
of the filter.
WASTE
If the swimming pool needs to be drained, this can be done using
the filter pump. In order to do this, the selector valve should be in
the "WASTE" position. The motor is run with the main drain valve
fully open, for the pump to have sufficient suction. For the pump to
suction, keep the prefilter and the main drain pipes full of water.
Before drainage, make sure that the skimmer valves and the bot-
tom cleaner valves are closed.
RINSE
After the carrying out the "BACKWASH" operation on the filter and
placing the installation in the "FILTER" position, the water flowing
into the swimming pool will be cloudy for a few seconds, so to pre-
vent it from reaching the swimming pool there is a "RINSE" position
for the selector valve which is operated as follows: immediately after
the "BACKWASH" put the valve in the "RINSE" position and switch
on the pump for 1 minute, after which the pump is switched off and
the valve placed in the "FILTER" position.
This position ensures that the filtered water goes directly to the
drain.
-08-
ENGLISH
FILTER
FILTRATION
FILTRACION
FILTRAZIONE
FILTERN
FILTER
FILTRATION
FILTRACION
FILTRAZIONE
FILTERN
FILTER
FILTRATION
FILTRACION
FILTRAZIONE
FILTERN