Cleaning And Maintenance - Princess Black Viper Cyclone Mode D'emploi

Temporarily parking the suction
nozzle (fig. G)
• To temporarily park the suction nozzle, use
the park position as shown.

Cleaning and maintenance

Before you proceed, we need you to pay
attention to the following notes:
- Before cleaning or maintenance, remove
the mains plug from the wall socket and
wait until the appliance has cooled down.
- Do not immerse the appliance in water or
any other liquids.
Before you proceed, we would like you to
focus your attention on the following notes:
- Do not use aggressive or abrasive cleaning
agents to clean the appliance.
- Do not use sharp objects to clean the
appliance.
• Regularly check the appliance for possible
damage.
• Regularly clean the ventilation slots using
a soft brush.
• Store the appliance in a dry place, out of
the reach of children.
Emptying the dust compartment
(fig. A, B & H)
The dust compartment (6) must be emptied
when the full indicator (4) comes on.
• Keep the release button (7) pressed and
pull the dust compartment (6) from the
appliance.
• Press the release button (26) and open the
cover (27).
• Carefully tap the dust compartment (6)
with your hand to remove the dust.
• Close the cover (27) until the release
button (26) clicks into place.
• Insert the dust compartment (6) into the
appliance until the release button (7) clicks
into place.
Cleaning the round filter (fig. B & H)
• Keep the release button (7) pressed and
pull the dust compartment (6) from the
appliance.
• Press the release button (26) and open the
cover (27).
• If necessary, empty the dust compartment
(6).
• Turn the round filter (28) clockwise to
remove the filter from the dust
compartment (6).
• Remove the dust from the round filter (28)
using a soft brush.
• Turn the round filter (28) counterclockwise
to insert the filter into the dust
compartment (6).
• Close the cover (27) until the release
button (26) clicks into place.
• Insert the dust compartment (6) into the
appliance until the release button (7) clicks
into place.
Cleaning and replacing the HEPA
filter (fig. B, I & J)
The appliance is equipped with a HEPA filter.
The HEPA filter is a special air filter which
removes more than 99% of the dust particles
that otherwise would recirculate back into the
air. The HEPA filter must be cleaned regularly.
The HEPA filter must be replaced after several
months or whenever worn or damaged.
Replacement HEPA filters are available from
our service station.
Before you proceed, we would like you to
focus your attention on the following notes:
- Do not wash or rinse the HEPA filter.
- Do not tap the HEPA filter itself to avoid
damage to the filter.
• Keep the release button (7) pressed and
pull the dust compartment (6) from the
appliance.
• Remove the HEPA filter (29) from the filter
holder (31).
• Carefully tap the plastic edge of the HEPA
filter (29) to remove the dust particles.
If the filter is worn, use a new filter.
• Insert the HEPA filter (29) into the filter
holder (31).
• Insert the dust compartment (6) into the
appliance until the release button (7) clicks
into place.
13