Roth DWT plus 3 620 Instructions De Montage Et De Service page 25

Row, block, angled installation
12
8 15
23
22 27 29
20
**
26
28 25
4 24 21
*
7
5
6
32
* dWt 1000 l
** with more than one block extension
important notes:
• Do not tighten fillpipe nuts with a pipe wrench;
forceful manual tightening (with protective glo-
ves) is sufficient.
• Check connections in regular intervals (e. g. be-
fore every 2nd filling) and tighten as necessary.
• Maximum supply amount: 60 l/h (adjusting
measure ments overfill prevention device see
installation instruction overfill prevention device)
15 13 11
9 14 10
17
19 29
18 27 23
30
28
3
31
• Only single strand piping (not communicating)
• Trim suction hose if needed
(e. g. oil sludge – 50 mm minimum above tank
floor)!
• Warranty granted only when these instruc-
tions and all regulations are followed!
We cannot accept liability for damages
caused by missing or misassembled parts!
Pos. Description
1 dWt 620 l/1000 l, complete
2 "füllstar" angled fill pipe,
complete with nuts, o-ring and
safety ring
3 "füllstar" 780 mm t-fill pipe,
complete with nuts, o-ring and
safety ring
16
4 "füllstar" angled manifold,
complete with nuts,o-ring and
safety ring
5 "füllstar" 780 mm (840 mm)
t-manifold, complete with nuts,
o-ring and safety ring
6 loRo-x fill connection (g2 alter-
natively), complete with fill pipe
nut, o-ring and safety ring
7 "füllstar" 310 mm fill pipe exten-
sion, complete with nut, o-ring
27
and safety ri ng
8 Angled ventilation piece, comple-
te with cap nut
9 T-ventilation piece, complete
with cap nut
10 angled manifold
11 t-manifold
2
12 connecting pipe 730 mm
13 connecting pipe 730 mm
(1100 mm*)
14 connecting pipe 150 mm
15 seal no . 8
16 compression seal for loRo-x
pipe
17 nBR flat seal
18 Supply fitting with overfill pre-
vention device
1
19 suction assembly fitting (exten-
sion)
20 Supply quick-action shut-off valve
21 supply angled piece
22 supply t-piece
23 supply pipe (alu-pipe) 760 mm
for row extension
24 supply pipe (alu-pipe) for quick-
action
shut-off valve 320/410 mm
(450 /650 mm*)
25 supply pipe (alu-pipe) 135 mm
26 supply pipe (alu-pipe) 760 mm
(1125mm*) for block extension**
27 knurled nut M 18 × 1 .5
28 o-ring Ø 9 .2 × 3 .5
ventilation
29 end plug
suction
30 cap nut
supply
31 Row extension spacer
32 Block extension spacer
25
Row (up to 5 tanks),
block (2-25 tanks)
and angled instal-
lation (3-14 tanks)
D
GB
F
I
NL