HumanTechnik Crescendo 50 Mode D'emploi page 11

Adjusting the operating mode selector
In order to use the amplifier's different options for picking up signals,
the selector in the battery compartment must be set to the corresponding posi-
tion. Set the operator mode selector as follows:
1. Open the battery compartment cover as described in »Putting in the batte-
ries«.
2. Use a small screwdriver to set the switch to the desired position.
The following three positions are available:
a. Position »M«: Operation using the built-in/external microphone. (If an
external microphone is used, the built-in microphone will be switched off
automatically.)
b. Position »A«: Switch position for the direct connection of any audio device
using a 3.5 mm stereo/audio cable.
c. Position »T«: Operation as an induction loop receiver.
What to do if the amplifier doesn't work
Make sure that the microphone cable or the headphone cable/teleloop cable is
not damaged in any way.
No sound
• Headphone/teleloop and microphone plugged into the wrong jack
-Check connections.
• Batteries dead
-Replace old batteries with new ones.
• Operating mode selector set to wrong position
-Set the operating mode selector in the battery compartment to »M« to use
the built-in microphone or the external plug-in microphone;
-If set to »T«, you are using your amplifier as an induction loop receiver.
Quiet or distorted sound
• Batteries almost dead
-Replace old batteries with new ones.
English 11