Section Vi. Stainless Steel Face Ring Assy. Instructions; Section Vii. Spectrum Amerlite (Sam) Replacement Parts - Pentair Spectrum Amerlite SAm Manuel Du Propriétaire

Section VI. Stainless Steel Face Ring Assy. Instructions.

1. Replace lens gasket. A NEW LENS GASKET MUST BE
USED EACH TIME THE LIGHT IS REASSEMBLED.
2. With the light resting on its base, place lens/gasket
assembly on light fixture and position so the white pointer
on the color wheel/bulb assembly points to the "O" in the
word "TOP" on the surface of the lens. See Figure 2.
3. Align the special pilot screw on the face ring with the
letter "O" of the word "TOP" on the surface of the lens.
The pilot screw, "O" in "TOP" and the white pointer on the
color wheel/bulb assembly should also align with the cord
compression fitting on the top rear of the light fixture.
4. With the bent ends of the circular uni-tension clamp
pointing down spread the clamp and place it in the "U"
recesses of the locking levers. Be sure the bent ends of
the clamp are located between the pair of locking levers as
shown in Figure 4, location A. Check to see that the clamp
is properly engaged with all of the levers.
5. Turn the light so that it is now resting on its lens. Tighten the screw and nut until the distance between the ends of
the clamp equals 1/4 inch or less; see Figure 5.

Section VII. Spectrum Amerlite (SAm) Replacement Parts.

6
7
9
10
Rev. A • Rev. A • Rév. A 6-5-01
1
2
Item
No.
1
1
3
1
2
4
3
5
4
8
5
6
7
8
9
10
11
11
SAVE THESE INSTRUCTIONS.
Figure 4.
Figure 5.
Part No. Description
79213100 Face ring, large plastic, snap-on, white
79213165 Face ring, large plastic, snap-on, gray
79213111 Face ring, large plastic, snap-on, black
79104800 Pilot Screw, with captive gum washer
79110600 Face ring assembly, S/S
79110400 Wire, uni-tension
79112000 Bolt
51008500 Washer
98216100 Nut, brass
79111000 Uni-tension wire clamp assy.
79100100 Lens, S Am , 8-3/8 in. dia., tempered
79101600 Gasket, 8-3/8 in. lens
79112400 Bulb, 75 watt, EYC, MR-16
NOTE
120V S Am 's have and integral 12V transformer.
All S Am' s use 12V lamp.
7
A
45 degrees
Bolt and nut are to be tightened at approx. 45 degrees
from the pilot screw between the tabs on the face ring
as shown above.
P/N • Núm/Pte. • Réf. P/N 619408