Section Iii. Switching Options For Spectrum Amerlite Color Synchronization; Section Iv. Sam Operating Instructions - Pentair Spectrum Amerlite SAm Manuel Du Propriétaire

Be sure to keep the special pilot screw from this underwater light. This screw mounts and electrically grounds the housing
securely to the mounting ring and wet niche. Failure to use the screw provided could create an electrical hazard which could
result in death or serious injury to pool users, installers or others due to electrical shock.
3. Remove Junction Box cover, disconnect the light fixture wires, and pull the cord through the conduit.
4. Feed the new light fixture cord through the conduit from the niche to the Junction Box.
Depending on the length of the conduit, special tools may be required to pull the cord through the conduit.
5. Leave at least 4 feet of cord to coil around the light fixture; see Figure 1. This 4 feet of cord coiled around the light
allows the light to be serviced after the pool is filled with water.
6. Cut the cord at the Junction Box, leaving at least 6 inches of cord to make connections.
7. Strip 6 inches of the outer cord jacket from the cord to expose the three insulated wires – be careful not to
damage the insulation on the three inner wires.
8. Connect all three wires to the corresponding circuit wires in the Junction Box (black wire to power, white wire to
common, and green wire to ground) and secure the Junction Box cover in place.
Never operate this underwater light for more than 10 seconds unless it is totally submerged in water. Without total submersion,
the light assembly will get extremely hot, which may result in serious burns or in breakage of the lamp or lens. This may result in
serious injury to pool users, installers, or bystanders, or in damage to property.
9. Replace light assembly into the niche and tighten the special pilot screw.
Use only the special pilot screw provided with this underwater light. This screw mounts and electrically grounds the housing
securely to the mounting ring and wet niche. Failure to use the screw provided could create an electrical hazard which could
result in death or serious injury to pool users, installers or others due to electrical shock.
10. Fill the pool until the underwater light is completely submerged in water before operating the light for more than 10
seconds. Turn on main switch or circuit breaker, as well as the switch which operates the underwater light itself,
to check for proper operation. Refer to Operating Instructions, Section IV., for full function test.

Section III. Switching Options for Spectrum Amerlite Color Synchronization.

A. Multiple SAm's ALWAYS in color synchronization.
1. If multiple SAm's are desired to always be on or off together and always with synchronized colors, multiple SAm's
may be controlled by a single switch to the extent allowed by code and capacity of the electrical equipment.
B. Multiple SAm's controlled separately but with color synchronize capabilities.
1. If on/off function or color of multiple SAm's is desired to be controlled separately, then SAm's should be controlled
by separate switches. It is recommended that the switches controlling SAm's be in immediate proximately of each
other to allow simple color synchronization.

Section IV. SAm Operating Instructions.

A. ON -- SAm turns on whichever color it was turned off.
st
B. 1 OFF/ON -- SAm fast forwards to white and pauses for up to 30 seconds, waiting for other SAm's to synchronize.
SAm then begins rolling through the Spectrum and will continue rolling until receipt of next switch command.
nd
C. 2 OFF/ON -- SAm holds on displayed color.
D. OFF/ON -- Repeats 1
E. OFF/ON Again -- SAm holds on displayed color.
P/N • Núm/Pte. • Réf. P/N 619408
st
OFF/ON sequence function.
WARNING
NOTE
WARNING
WARNING
4 Rev. A • Rev. A • Rév. A 6-5-01