Section V. Replacing Lamp's Only - Pentair Spectrum Amerlite SAm Manuel Du Propriétaire

If multiple S Am 's are preferred in color synchronization, the above should be performed on respective switches simulta-
neously. If they are desired on different colors they should be switched separately.
Section V. Replacing lamp's only, see Figure 2.
Always disconnect power to the pool light at the circuit breaker before servicing the light. Failure to do so could result in
death or serious injury to installer, serviceman, pool users or others due to electrical shock.
1. Turn off main electrical switch or circuit
breaker, as well as the switch which
operates the underwater light itself.
2. You will need to get the following items.
a. A new lens gasket, p/n 79101600.
b. Two (2) lamps, see Table 1.
Replace the lamp with a similar type and wattage. Failure to replace the lamp with the same type of lamp will damage the
light assembly and may cause an electrical hazard resulting in death or serious injury to pool users, installers, or others due to
electrical shock, and may also cause damage to property.
Always install a new lens gasket (part number 79101600) whenever disassembling the light. Failure to do so may permit water
to leak into the assembly which could cause:
(a) an electrical hazard resulting in death or serious injury to pool users, installers, or others due to electrical shock, or
(b) breakage of the lamp or lens, which likewise could result in serious injury to pool users, installers, or bystanders, or in
damage to property.
3. To remove light assembly, remove the special pilot screw
at top of face ring, remove light assembly from niche, and
gently place assembly on deck. You are not required to
drain down the pool.
Be sure to keep the special pilot screw from this underwater light.
This screw mounts and electrically grounds the housing securely to
the mounting ring and wet niche. Failure to use the screw provided
could create an electrical hazard which could result in death or
serious injury to pool users, installers or others due to electrical shock.
Transformer required on 12 volt models.
4. Disassemble light fixture and remove bulb.
a. With a ¼" nut driver, remove 4 bulb plate retainer nuts
and place in a secure location, see Figure 3.
b. Lift color wheel/bulb assembly to clear bolts, then
swing up and rest vertically in light fixture to provide
bulb access, see Figure 3.
Rev. A • Rev. A • Rév. A 6-5-01
WARNING
NOTE
NOTE
DANGER
Lamp's Specifications *
Fixture Bulb
Voltage Voltage
120V 12V
12V 12V
* NOTE: Both 120V and 12V S Am' s use the same 12V bulb.
WARNING
WARNING
5
Bulb
Wattage Lamp Type
75W EYC
75W EYC
Lens
Gasket
Color Wheel/
Bulb Assembly
Color Wheel/
Bulb Assembly
Mounting Studs
and Nuts (4)
Light Housing
P/N • Núm/Pte. • Réf. P/N 619408
Table 1.
P/N
79112400
79112400
Figure 2.