Beurer UB 90 Mode D'emploi page 12

Additional information UB 100
The area intended for the head
cannot be heated.
Guide the plug-in coupling plug
through the slot on the side section
[9] and then connect the switch to
the electric underblanket by plug-
ging together the plug-in coupling
[8] (see figure).
Then pull the side section over the sides of your mattress like a fitted sheet. The electric under-
blanket is designed to fit 90 x 200 cm as well as 100 x 200 cm mattresses. If the cable length is
insufficient, you can order a longer power supply cord with the material number 108.424 from
our specified Customer Service. Then fit your fitted sheet as usual with the electric underblan-
ket positioned between your mattress and the fitted sheet.
4.3 Switching on
Slide the ON/OFF switch [6] sideways [1] to the ON ( I ) position to switch on the electric under-
blanket.
When switched on, the display [2] lights up and at first displays all the segments for approx. 2
seconds. After that, the following basic settings are displayed:
Temperature setting for body area: 0
Temperature setting for foot area: 0
Automatic switch-off time: 1 h (= 1 hour)
Note: The illuminance level drops after approx. 5 seconds so that your sleep is not disturbed
during the night.
Note: This electric underblanket has a rapid heating function, allowing for faster
warming in the first 15 minutes. During this time, "Turbo" flashes on the display.
If the underblanket is rapidly switched off and then on again during the first 15 min-
utes, the fast heating function is deactivated for safety reasons.
In this case the word "Turbo" does not appear on the display. However the electric underblan-
ket is heated as normal.
To reactivate the fast heating function the electric underblanket must be completely switched
off for 20 minutes.
4.4 Switching off
Slide the ON/OFF switch to the OFF ( 0 ) position to switch off the electronic underblanket.
When switched off, the illumination and the display are turned off.
4.5 Setting the temperature
Press the button [3] to select the temperature setting for the body area.
Press the button [5] to select the temperature setting for the foot area.
Level 0: off
Level 1: minimum heat
Level 2 – 8: individual heat
Level 9: minimum heat
Note: Switching sequence of the temperature settings: 0 – 9 – 8 – 7 – 6 – 5 – 4 – 3 – 2 – 1 – 0 – 9 ...
12