emerio FH-121956 Mode D'emploi page 7

soon as the set temperature is reached. You can long press the button "
panel for rapid adjustment.
3. Time setting
Press button " " in the control panel and hold on for 5 seconds, the timer shows in the display. Press
button " " or "
working time is flashing 3 times, and then the time setting is done. The appliance will shut itself off
automatically when the time is up.
You can long press the button "
Note: The button "MODE" in the remote control cannot be used to set timer, it can only set mode.
4. Horizontal rotation
Press button " " in the control panel, the appliance begins to rotate. Press button "
oscillation will be off.
5. ECO mode
Press button "ECO" in the remote control, the appliance will be in ECO mode. The appliance will
automatically maintain the room temperature in 16℃.
6. Light button
Press button "LIGHT" in the remote control to turn on or turn off the indicator light.
7. Turn off
Press button " " again to turn off the appliance. Turn off the main power switch and unplug the power
cord from the outlet.
SAFETY SYSTEM
The appliance has a safety system which automatically switches off the unit when overheated.

If overheating occurs, switch off the appliance, remove the plug from the socket, and let it cool down

for at least 30 minutes. Put the plug in the socket and switch on the heater.
This heater is equipped with a tilt protection safety device. For safety reasons, the unit will

automatically switch off the power if it is put on unstable or uneven surfaces or if it is tilted
accidentally.
MAINTENANCE
The fan heater only needs regular cleaning on the outside.

Before you clean the unit, turn off the switch. Remove the plug from the socket and wait until the fan

heater cools down completely.
Use a damp cloth to wipe the heater housing and use a vacuum cleaner or a dusting brush to clean the

air inlet grille and outlet grille.
Do not use detergents, abrasive cleaning liquids or chemicals (alcohol, gasoline etc.) to clean the

appliance.
Never immerse the appliance in water!

" in the control panel to set the desired working time from 0 hour to 9 hours. The set
" or " " in the control panel for rapid adjustment.
- 6 -
" or " " in the control
" again, the