Maytag MDB7759SAB Instructions D'utilisation page 6

OPTION SELECTIONS
OPTIONS dish load types
Tough food soils
All loads
Loads requiring extra
To sanitize your dishes
and glassware
All loads
All loads
CONTROLS AND CYCLE STATUS
CONTROL PURPOSE
To start or resume a
wash cycle
To reset any cycle or
options during
selection.
To cancel a wash
cycle after it's
started.
To turn the audible
tones on or off.
6
DESCRIPTIONS
Increases the target water
temperature during the wash portions
of the cycle. Adds heat, time, and
water.
Use for best drying results in
combination with rinse aid. Turn off
when loads contain plastic
dinnerware that may be sensitive to
higher temperatures.
Use for best drying results in
combination with rinse aid. Turn off
drying
when loads contain plastic
dinnerware that may be sensitive to
higher temperatures.
Raises the water temperature in the
final rinse to approximately 154°F
(68°C). This high temperature rinse
sanitizes your dishes and glassware
in accordance with NSF/ANSI
Standard 184 for Residential
Dishwashers. Certified residential
dishwashers are not intended for
licensed food establishments.The
Sanitize option adds heat and time to
the cycle.
Delays the start of a cycle up to
8 hours.
When Control Lock is lit, all buttons
are disabled. If you press any pad
while your dishwasher is locked, the
light flashes. The door can be opened
while the controls are locked.
COMMENTS
If the door is opened during a cycle or the power is interrupted, the START/RESUME
indicator flashes. The cycle will not resume until the door is closed and START/RESUME is
pressed.
NOTE: If the START/RESUME button is located on top of door, push door firmly closed
within 3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds,
the start button LED will flash, an audible tone will be heard, and the cycle will not start.
Press CANCEL/DRAIN to reset any control selections made.
See "Canceling A Cycle" and "Changing a Cycle After Dishwasher Is Started" sections.
Press and hold the Hi Temp Wash button for 3 seconds to turn the audible tones on or off.
Only audible tones for confirming button presses can be turned on/off. Important audible
tones, such as indicating a cycle has been interrupted, cannot be deactivated.
USE WITH:
Jet Clean Plus Steam, Normal,
and Auto Clean
Jet Clean Plus Steam, Normal,
Light, Quick Wash and Auto Clean
Jet Clean Plus Steam, Normal,
Light, Quick Wash and Auto Clean
Jet Clean Plus Steam, Normal,
and Auto Clean
All cycles
All cycles
ADDED
TIME TO
CYCLE
10 min.
45 min.
90 min.
30 min.
2, 4, 8
hours