Table des Matières
Publicité
APPENDIX
1. Switch Number Settings
The factory settings CL10 Switch number is Switch "1".
When two or more Switches are used in the same installation, it is required to
setup every CL10 Switch with a different switch number (example Switch 01,
02, 03, etc).
If required, set the Switch Number with jumpers J22 and J23.
Switch Number
settings
(1, 2, 3, etc.)
2. Multiplexor Connection
Connect every CL10 Switch to a Multiplexor using a RJ9-RJ9 straight cable
from J3 connector in the switch side to any free port in the Multiplexor side.
3. Booths Telephone Line connection.
Connect the 2 Line wires from every Booth Unit to the CL10 Switch connectors
labelled as "CABINAS".
4. Default Telephone Lines
Connect the 2 Inbound Telephone Line wires for every Booth to the CL10
Switch connectors labelled as "LINEAS".
5. Secondary Telephone Line.
Connect the 2 Secondary Telephone Line wires to the Auxiliary Lines
Expansion cards in the CL10 Switch.
95
CL10 EVOLUTION
Connection to
Multiplexor
(RJ9)
Publicité
Table des Matières
