Explanation Of Functions/Terms Used - Selve i-R Send 5 Mode D'emploi

GB

Explanation of functions/terms used

Explanation of functions/terms used
Transmission control light
A radio signal is indicated by the transmission control light being
lit.
Pressing and holding the UP, DOWN, STOP or the PROG button
on the transmitter for a few seconds will cause the transmission
control light to go out briefly after 3, 6 and 9 seconds. This function
serves as a counting aid. After 12 seconds the transmission
control light will go out entirely.
If the battery starts running out, the transmission control light
flashes during transmission.
The transmitter power and/or radio range is reduced when the
battery is running low. If the transmission control light is
no longer lit when the button is pressed, the batteries must be
changed.
Group control
Group control means controlling one or several receivers at
the same time. The selected group is activated using a single
command.
When the group radio hand transmitter is used, the groups are
controlled using six radio channels.
Group selector
The group selector may be used to select up to 5 channels.
Operation of the individual channels is indicated by the relevant
LED lighting up.
An additional channel is reserved for the central command. This
is allocated automatically. Operation of the central command is
indicated by all five LEDs lighting up.
Note: You can note the programmed group on the label under
the see-through cover.
Fichier téléchargé sur http://www.servistores.com
24