Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
cloth to clean it, avoid cleaners and
solvents.
•
Always check that the shredder and
especially the guards are not worn
down or damaged but firmly attached
before use. Check that the nuts, bolts
and screws are tight.
•
Check the covers and guards for
damage and improper attachment. If
necessary, change the components
•
Keep the shredder in a dry place out
of children's reach. Do not cover the
shredder in nylon bags, as moisture
may develop.
D
Sharpening, turning or
replacing the blades
Before starting to service or clean
the unit, turn off the unit, pull the
power plug, and wait until the blade
stands still. There is a risk of injury
and a risk to life from electric shock,
fire and rotating blades.
•
Check that the power plug (
pulled properly.
•
Unlock the housing interlock (10).
•
Tip forward the front part of the
shredder housing.
•
Undo the 8 mounting screws (22) on
the cover plate (23) of the shredding
machine. You can now remove these
and place them aside.
•
You now have full access to the blade
(21).
•
You can use the Allen key (18) to
loosen the screws (20) of the blades
(21) and remove the blades (21).
To assemble the blade you must
use a new screw and tighten it
with an torque of 16 Nm.
Replacement parts
Spare parts and accessories can be
obtained at www.service-deltafox.de
If you have issues ordering, please use
the contact form. If you have any other
questions, contact the service centre (see
page 123).
4 Screw + 2 Blade .................... 91105563
Waste disposal and
environmental protection
Be environmentally friendly. Return the tool,
accessories and packaging to a recycling
centre when you have finished with them.
Hand over the device at an utilization loca-
tion. The plastic and metal parts employed
A
7) is
can be separated out into pure materials
and recycling can be implemented. Ask
your Service Center about this.
Machines do not belong with dome-
stic waste.
GB
27
Publicité
Chapitres
Table des Matières
Dépannage
