Using Your Tv - Insignia NS-42PDP Guide De L'utilisateur

Connecting a computer
Warning
Make sure that you turn off and unplug your TV before
installing devices.
Use the following illustration to connect a
computer to your TV.
Back of TV
Audio cable
D SUB cable
Computer
To watch TV on your computer monitor:
1 Turn on your TV.
2 Press the INPUT button one or more times to
select VGA.
3 Turn on your computer, then set up your
computer for external VGA input. See your
computer documentation for more
information.
14

Using your TV

Turning your TV on and off
To turn on your TV:
1 Make sure that the power cord is connected
to your TV and an electrical outlet.
2 Press the
3 Press the
Selecting the TV source
To select the TV source:
1 Press the MENU button.
2 Press the
to highlight Setup, then press the OK or
button to open the Setup menu.
3 Press the
to highlight Tuning Band, then press the OK
or button to access the tuning band
options.
4 Select Air for an outside antenna. Select
Cable, Cable HRC, Cable IRC, or Cable
Auto for cable TV. We recommend that you
select Cable Auto for cable TV. For more
information about cable TV selections,
contact your cable TV provider.
5 Press the EXIT button to close the on-screen
menu system.
Setting up the channel list
After you select your TV source (antenna or
cable), you need to set up the channel list. When
you set up your channel list, your TV searches
for all available channels in your area and stores
a list of the channels. When your press the
CH or
or + button on the remote control, your TV skips
the channels that do not have a signal.
www.insignia-products.com
Insignia NS-42PDP 42" Plasma TV
button to turn on your TV.
button again to turn off your TV
or button one or more times
or button one or more times
on the front of your TV or the CH –