Operating Globrite Color Lights Using A Wall Switch; Powering On The Globrite Led Lights - Pentair GLOBRITE Guide D'installation Et De L'utilisateur

2
Operating GloBrite
GloBrite Color Lights can be controlled using a standard wall-mount light switch or by the
IntelliBrite Controller (see page 3). Multiple GloBrite color lights can be connected via a
®
junction box and a 12 VAC transformer to a single switch so that all lights can be switched
on and off together. GloBrite color lights are controlled by cycling AC power to the 12
VAC transformer from a standard wall switch. By turning the switch on and off a specific
number of times, the light activates one of the seven light show modes, fixed colors, or
enables the "Hold" and "Recall" feature.
Powering on the GloBrite Color LED Lights
When the GloBrite color light is powered on, the previously selected color is displayed,
unless the HOLD or RECALL feature was previously enabled.
Note: If power to the light is off for more than five (5) seconds, the last color show mode or
fixed color that was saved will be displayed.
Selecting a GloBrite Color Light Show Mode or Fixed Color using a Wall
Switch
GloBrite color lights are compatible with IntelliBrite color light colors and shows and can be
synchronized with IntelliBrite color lights.
First switch power on to the light. A white light will momentarily illuminate, followed by the
previously selected color. To select a color show mode (1-7) or fixed color
(8-12), turn the wall switch off/on a specific number of times. Each number (1-12) shown
below corresponds to the number of times to power-cycle the switch to activate a color
light show or fixed color. For details about saving color effects while in "show" modes, see
"Hold" and "Recall" feature on page 3.
SAm Mode: Cycles through white, magenta, blue and green colors
1
(emulates the Pentair SAm
Party Mode: Rapid color changing building energy and excitement.
2
Romance Mode: Slow color transitions creating a mesmerizing and
3
calming effect.
Caribbean Mode: Transitions between a variety of blues and greens.
4
American Mode: Patriotic red, white and blue transition.
5
California Sunset Mode: Dramatic transitions of orange, red and
6
magenta tones.
Royal Mode: Richer, deeper color tones.
7
Blue: Fixed color.
8
Green: Fixed color.
9
10 Red: Fixed color.
11 White: Fixed color.
12 Magenta: Fixed color.
13 Hold: Save the current color effect during a color light show.
14 Recall: Activate the last saved color effect.
®
Color Lights Using a Wall Switch
color changing light).
®