Pentair GLOBRITE Guide D'installation Et De L'utilisateur page 13

Installing GloBrite
To install the GloBrite color light niche in a vinyl liner pool:
1. Drill a 7.62 cm (3 in) hole in the desired location for the light vinyl niche.
2. From the inside of the pool, insert the vinyl niche through the 7.62 cm (3 in)
hole.
3. Install the plastic nut onto the back of the niche. Hand tighten the nut to
secure the niche in place.
4. Place the sealing gasket onto the front of the niche as shown below.
5. Install the vinyl liner.
6. Install the conduit. See Figure 2 on page 8.
7. Using the alignment tabs on the niche, carefully align the faceplate to the
niche. Once the faceplate is properly aligned, pierce liner through faceplate
and install the screws one at a time.
8. Using a No. 2 Phillips head screwdriver, hand tighten each retaining screw to
secure the cover. DO NOT OVER TIGHTEN THE SCREWS. DO NOT USE
A POWER TOOL TO SECURE THE SCREWS. Over tightening or using a
motorized screwdriver on the sealing ring screws can over torque the screw
threads and damage the niche housing and/or vinyl liner seal.
2.54 cm (1 in) Conduit
®
Color Light Niche in a Vinyl Pool
Wall panel
Niche
Nut
GloBrite Color Changing LED Pool/Spa Light Installation and User's Guide
Liner
Face Plate
Sealing Gasket
9
Stainless steel
screws (x4)