Troubleshooting - Pentair GLOBRITE Guide D'installation Et De L'utilisateur

Wiring GloBrite
300 Watt Transformer
The following diagram shows how to connect GloBrite
Controller using a 300 Watt transformer. Note: For GloBrite light operating
instructions, see page 2.
GREEN
WHITE
BLACK
120 VAC from
pool panel circuit
breaker
Troubleshooting (GloBrite Lights)
Both of the LEDs are flashing: Check the light wiring connection to the junction
box at the pool side and to the AC power switch.
Light does not function properly: Be sure that there is proper AC power applied to
the light.
Troubleshooting (IntelliBrite Controller)
Both of the LEDs are flashing: The IntelliBrite Controller has detected that the
load has exceeded the maximum allowable wattage or the output is shorted out
1. Switch off the IntelliBrite Controller OFF. Remove excessive load or short.
2. Press the IntelliBrite Controller power switch to power on the unit. Verify the
LEDs are no longer flashing.
®
Color Lights to IntelliBrite
wire nut
IntelliBrite Controller
GloBrite Color Changing LED Pool/Spa Light Installation and User's Guide
®
Controller and
color light to an IntelliBrite
®
GREEN
WHITE
BLACK
120 VAC Input
12 VAC
Transformer
12 VAC Output
GloBrite Lights
12 VAC
19
300 Watt
Transformer
AC Power cord