Maytag MDB8959AWS Instructions D'utilisation page 6

OPTION SELECTIONS
OPTIONS DISH LOAD TYPES
Loads containing tough,
baked-on food.
To run your dishwasher at
a later time or during off-
peak hours.
Control Lock To avoid unintended use of
your dishwasher, or cycle
and option changes during
a cycle.
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat and water as needed.
CONTROLS AND
CYCLE STATUS
CONTROL PURPOSE
To start or resume a
wash cycle
To cancel wash
cycle
To follow the
progress and status
of your dishwasher
cycle
6
DESCRIPTIONS
Increases the target water temperature during the wash
portions of the cycle.
Adds heat, wash time and water to the cycle.
Delays the start of a cycle up to 6 hours.
Select a wash cycle and options. Press Delay. Press START/
RESUME. Close the door firmly.
To turn on Lock, press and hold Heated Dry for at least
3 seconds.
To turn off Lock, press and hold Heated Dry for at least
3 seconds.
When Control Lock is lit, all buttons are disabled. If you press
any pad while your dishwasher is locked, the light flashes
5 times. The dishwasher door can be opened while the
controls are locked.
COMMENTS
If the door is opened during a cycle or the power is interrupted, all lights will flash to indicate a
suspended cycle. The cycle will not resume until the door is closed and the START/RESUME
button is pushed.
Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely.
The "Clean" indicator glows when a cycle is finished.
If you select the Sanitize option, when the Sanitize cycle is finished, the Sanitized indicator glows.
If your dishwasher did not properly sanitize your dishes, the light will not come on. This can
happen if the cycle is interrupted, or the water could not be heated to the required temperature.
The clean and sanitize lights go off when the door has been opened for more than 30 seconds or
the CANCEL key is pressed.
The "Washing" indicator glows at the start of the first fill of any cycle (except Rinse Only) and
remains on until the end of the main wash cycle.
The "Drying" indicator glows during the drying portion of each cycle (except Rinse Only).
USE WITH:
Heavy, Normal, and
Auto Clean Plus cycles
All cycles
Anytime