Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Before you begin
Read these instructions completely and carefully.
IMPORTANT –
•
IMPORTANT –
•
Note to Installer –
•
Be sure to leave these instructions with the Consumer.
Note to Consumer –
•
Skill level
•
– Installation of this appliance requires basic mechanical and electrical skills.
Completion time
– 1-3 hours.
•
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered under the Warranty.
FOR YOUR SAFETY
WARNING
• This appliance must be properly grounded and
installed as described in these Installation
Instructions .
• Do not install or store appliance in an area where it
will be exposed to water/weather. See Location of
Your Washer section.
TOOLS REQUIRED FOR
WASHER INSTALLATION
Bubble level
Pliers
LOCATION OF YOUR WASHER
Do Not Install the Washer
1. In an area exposed to dripping water or outside
weather conditions. The ambient temperature
should never be below 60°F (15.6°C) for proper
washer operation.
2. In an area where it will come in contact with
curtains or drapes.
3. On carpet. The floor MUST be a hard surface with
a maximum slope of 1/2" per foot (1.27 cm per
30 cm). To make sure the washer does not vibrate
or move, you may have to reinforce the floor.
4
Save these instructions for local inspector's use.
Observe all governing codes and ordinances.
Keep these instructions for future reference.
Phillips screwdriver
Flat-blade screwdriver
• NOTE: This appliance must be properly grounded,
and electrical service to the washer must conform
with local codes and ordinances and the latest
edition of the National Electrical Code, ANSI/NFPA 70.
PARTS SUPPLIED
Water Hoses (2)
Seal (4)
Seals could probably
be inserted in the hoses.
Hose Guide (1)
Cable Tie (1)
Publicité
Table des Matières
