GE PTAN9150MWW Manuel De L'utilisateur page 17

PERFORMANCE
The clothes are too
wrinkled or tangled
Wash cycle takes a
long time
Clothes too wet
Washer doesn't wash
properly
Possible Causes
Did not remove clothes from
your washer once
the cycle was finished.
Load wasn't properly
distributed or washer was
overloaded.
Incorrect cycle selection
Oversudsing due to too
much detergent, causing
extra drains and fills to
remove the excess.
Overloaded, causing
extra fills
Some cycles have a short
spin time, such as Colours,
Delicates, Speed wash, and
Washable wool.
Excessive sudsing due to
excessive detergent or
use of high suds detergent.
Clothing with stubborn
stains
Overloaded washer with
very dirty clothes
What To Do
• Take out your clothes soon after cycle ends, it helps to
reduce wrinkles.
• To reduce tangles and wrinkles, it's important to place the
clothes according to user's manual or quick guide.
• Load your washer according the suggested
load table.
• Match cycle selection to the type of fabric you are washing
• You can reduce the quantity of wrinkles by selecting a lower
spin level if required
• Using fabric softener helps to reduce wrinkles
• To minimize wrinkles even more, it's recommended to dry
your load in a clothes drye
• Use less detergent.
• Use low-suds detergent (liquid preferably)
• Load clothes no higher than the line in the the wash basket
ring.
• You can modify the spin length using the Spin Level knob
• If the clothes are too wet, select a Drain and Spin cycle
(on some models) or select the Rinse and Spin option.
• Soak or pretreat stains with commercial stain remover.
• Use the Heavy Duty cycle
• If the clothes being washed will allow it, you can select the
Hot wash temperature. Please refer to care instructions on
each article of clothing.
• Match cycle selection to the type of fabric you are washing
• When your clothes are very dirty, you should separate into
smaller loads as it will help increase the wash performance
www.geappliances.ca
17