Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Unfolding
Pull the foot slightly out (photo 2) and pivot it until it stops
(photo 3). Now press the foot backwards until it audibly
clicks into place (photo 4). Check that it is locked proper-
ly.
2
3
Adjustment of the seat and backrest
To adjust the seat surface or the backrest, pull the res-
pective single-hand control (photo 5-6).
Swivel the seat surface or backrest into the desired posi-
tion (four increments possible). Ensure that the seat sur-
face or backrest has correctly clicked into place.
5
Use of the headrest and strap
The chest strap and the headrest can be individually ad-
justed using a Velcro closure system (photo 8). The width
of the headrest can additionally be adjusted by simply
pushing both side supports.
7
10
Drive Medical GmbH & Co. KG | As per: 21.04.2021 | Errors and alterations excepted
4
6
8
Optional accessories
The following optional accessories are additionally
available:
1.
Shower support base frame
2.
Bath support base frame
A click system enables quick conversions. Simply click
the feet of the bath support into the red locking mecha-
nisms. To disassemble, pull the red toggle lever.
Cover
To change the cover, remove the single-hand controls
as shown (photo 9). Then the cover can be pulled off
(photo 10). The cover can be washed in the machine up
to 60°C.
9
Cleaning and maintenance
• Clean regularly with a moist cloth!
• Do not use any aggressive cleaning agents!
• Do not use abrasive cleaners!
• Do not use any high-dose chlorine and vinegar-based
cleaners!
• To disinfect, a spray disinfectant can be used such as
Descosept AF or Bacillol AF.
• Check the screws regularly and tighten, if necessary.
• The product should not be exposed to temperatures
above 60°C for long periods of time (for example, use
in a sauna, etc.)
• In the event of defects, contact your specialist dealer
from whom you purchased this product.
10
Instructions for use OTTER
Publicité
Chapitres
Table des Matières
