Klarstein 10033188 Mode D'emploi page 69

• After selecting the pyrolytic self-cleaning mode and well set working time, touch
the start button (K3) to start working. At this time the working time setting icon (2)
will be displayed, the door lock will be activated, the door lock icon (10) will
always be displayed, indicating that the oven door has been locked and pyrolytic
self-cleaning mode starts, touch the pause/cancel button (K4) can pause or cancel
the function.
• In this mode, the time to the end of self-cleaning is counted down. After the self-
cleaning function is confi rmed and started, clock position shows countdown time,
temperature position shows "PYR". The oven lamp cannot be used after pyrolytic
self-cleaning mode begins.
• After the start of self-cleaning, the door lock function will be activated
automatically, the oven door will be locked, self-cleaning process starts. If after
self-cleaning process starts, display screen shows fault code "E-3", please refer
to protection function for problem analysis (see section „Protection functions" in
chapter „Operating functions"), you can touch the pause/cancel button (K4) to
cancel the fault code and return to standby mode. After clearing the fault code,
reset self-cleaning function and touch the start buttion (K3) again to start.
Notes on pyrolytic self-cleaning mode
CAUTION
Risk of burns! When using the self-cleaning function, the outside
temperature of the oven will be higher than normal cooking
temperature. Do not touch the cavity casing and ensure children are
kept away from the oven to avoid getting hurt.
• Before use of the pyrolytic function, you must remove the side shelf, oven pan and
other relative accessories to avoid damage in the high temperatures reached in the
cycle.
• After using the pyrolytic function, do not use water or other washing agents.
• Before using the pyrolytic function, remove food residue and spillages from inside of
the oven cavity and prevent making a large amount of smoke and irritating smells
during the cycle.
• When using the self-cleaning function, the oven can produce smoke and irritant
smell, please keep the room well ventilated.
• After use the pyrolytic function, you may fi nd matter which was not removed in the
side of the cavity, this is to be expected. Use a microfi ber cloth to remove.
• Contact customer service, if the seal of the oven is found to be faulty or damaged. It
should be replaced by a suitably qualifi ed person and only a genuine replacement
door seal should be fi tted. Do not use alternative door seals as they may not be
suitable. Do not replace the oven seal yourself.
EN
69