Klarstein 10033188 Mode D'emploi page 59

Reservation function: Setting the end of the preparation time
• After well set the cooking time and temperature and before pressing the start button
(K3), touch the clock button (K2) to enter the cooking end time setting/reservation
function (default end time = system time + set cooking time.)
• The cooking end time icon (3) will flash (1 time/second), display screen clock
place hour value will flash at this time. Rotate the programming switch (KB2) to set
the hour time.
• After you set the hour time, touch the clock button (K2) again and enter the minute
time setting. At this time, the minute value of the clock position flashes, and the
minute time can be set by rotating the programming switch (KB2). You can use the
clock button (K2) to switch hour and minute settings circularly.
• After the cooking end time setting is completed, touch the start button (K3) to start.
• The oven will enter reservation status. The longest reservation time is 24 hours.
• Under reservation status the display screen will display as shown on the picture
below. All elements and motors will not work at this time.
• Reservation status display: The cooking end time icon (3) and the clock icon (9)
will be displayed, the clock position shows the system time, corresponding selected
function icon will be displayed and the temperature place will display set cooking
temperature.
• If more than 10 seconds are not confirmed during setting reservation function, the
oven will automatically return to standby state.
• If you need to cancel the set reservation under reservation status, you can touch the
pause/cancel button (K4) to cancel it and the oven will enter to standby mode.
Pyrolytic self-cleaning mode
• For details on the pyrolytic self-cleaning mode, refer to the "Automatic cleaning" in
the „Cleaning and maintenance" chapter of this manual.
Reservation status display effect
EN
59