Klarstein 10033188 Mode D'emploi page 62

EN
62
4 During self-cleaning process, if display screen shows fault code "E-3" when door is
not close to place, it means door is not close to place.
• For the above situations when showing fault code, buzzer will continuously prompt
for 10 times,1s/time (display effect as shown in picture below). Touch pause/
cancel button (K4) can return to standby status.
Door lock abnormal alarm display effect
Time enquiry function
1. Under cooking state, touch the clock button (K2) once can query system time, clock
position shows the current time, second icon will flash. Touch the clock button (K2)
again or 10 seconds later automatically return to cooking time display.
2. At the alarm time setting, reservation or cooking state, touch the reminder button
(K1) can query the alarm clock remaining countdown. Touch the clock button (K2)
again or 10 seconds later automatically return to its original state. You can query
the remaining alarm clock time and reset the alarm clock time under standby state,
when the alarm countdown time is less than 1 minute, clock position shows "0:00".
3. In the reservation status, touch of the clock button (K2) can query the cooking start
time, clock position shows the cooking start time, cooking start time and the working
time setting icon (2) flash. Touch the clock button (K2) again or 10 seconds later
automatically return to the system time display.
Alarm function
• Touch the reminder button (K1) under standby state to enter to alarm function
setting, this time the clock position hour value will flash, the minute value will long lit
and the alarm icon (1 1) will keep bright.
1. Rotate the programming switch (KB2) to set the hour time, at this time the hour value
is always bright, the value setting range is 0–23.
2. Touch the reminder button (K1) again, the minute value will flash, and the hour
value keeps bright.
3. Rotate the programming switch (KB2) to set the minute time, at this time the minute
value will always bright, the value setting range is 0–59.