Backlight; Maintenance; Battery Replacement; Cleaning The Rain Collector - Explore Scientific WSX1001 Mode D'emploi

Masquer les pouces Voir aussi pour WSX1001:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

6. Press [ ALERT ] key to step to next alert reading.
High /Low
Alert on
7. Press any key on the front side to save alert on /off status and back to normal mode, or it
will automatically back to normal mode after 30 seconds without pressing any key.
TO SILENCE THE ALERT ALARM
Press [ALARM / SNOOZE] key to silence the alert alarm or let the alarm automatically turn off
after 2 minutes.
NOTE:
- Once the alert is triggered, the alarm will sound for 2 minutes and the related alert icon and
readings will flash.
- If the alert alarm is automatically off after 2 minutes, the alert icon and readings will still keep
flash until the weather reading is out of the alert range.
- The weather alert will sound again when the weather readings falls into the alert range again.

BACKLIGHT

The main unit backlight can be adjust, using the [ HI / LO / AUTO ] sliding switch to select the
appropriate brightness:
- Slide to the [ HI ] position for the brighter backlight.
- Slide to the [ LO ] position for the dimmer backlight.
- Slide to the [ AUTO ] position for the auto adjust backlight that according to environment light
level.

MAINTENANCE

BATTERY REPLACEMENT

If the low battery indicator "
OUT or CH section, it indicates that the current
channel wireless or outdoor 5-in-1 sensor
battery power is low. You should replace all the
batteries in the current channel sensor at once.

CLEANING THE RAIN COLLECTOR

1. Unscrew the rain collector by turning it 30°anti-clockwise.
2. Gently remove the rain collector.
3. Clean and remove any debris or insects.
4. Install the collector when it is clean and fully dried.

CLEANING HYGRO-THERMO SENSOR OF WIRELESS 5-IN-1 SENSOR

1. Remove the 2 screws at the bottom of the radiation shield.
2. Gently pull out the shield.
3. Carefully remove any dirt or insects on the sensor casing (do not
let the sensors inside get wet).
4. Clean the shield with water to remove any dirt or insects.
5. Install all the parts back when they are clean and fully dried.
Alert on
" displayed in
Alert off
N
23
Alert off
N
N
"Lock" Position
"Unlock" Position

Publicité

Table des Matières
loading

Table des Matières