Comfort Indication; Wireless Sensor Signal Receiving; Wind - Explore Scientific WSX1001 Mode D'emploi

COMFORT INDICATION

The comfort indication is a pictorial indication based on indoor air temperature and humidity in
an attempt to determine comfort level.
Too cold
NOTE:
- Comfort indication can vary under the same temperature, depending on the humidity.
- There is no comfort indication when temperature is below 0°C (32°F) or over 60°C (140°F).

WIRELESS SENSOR SIGNAL RECEIVING

1. The console display signal strength for the wireless 5-IN-1 sensor, as per table below:
No signal
2. If the signal has discontinued and does not recover within 15 minutes, the signal icon will
disappear. The temperature and humidity will display "Er" for the corresponding channel.
3. If the signal does not recover within 48 hours, the "Er" display will become permanent. You
need to replace the batteries and then press [ SENSOR / WI-FI] key to pair up the sensor
again.
VIEW OTHER CHANNELS (OPTIONAL FEATURE WITH EXTRA SENSORS)
This console is capable to pair with a wireless 5-IN-1 sensor and up to 7 wireless thermal-hygro
sensors. If you have 2 or more sensors, you can press [ CHANNEL ] key to switch between
different wireless channels in normal mode, or press and hold [ CHANNEL ] key for 2 seconds
to toggle auto-cycle mode to display the connected channels at 4 seconds interval.
During auto-cycle mode, press [ CHANNEL ] key to stop auto cycle and display the current
channel.

WIND

WIND SPEED AND DIRECTION SECTION OVERVIEW
TO SET THE WIND SPEED UNIT AND DIRECTION DISPLAY FORMAT
1. In normal mode, press and hold [ WIND ] key for 2 seconds to enter into wind speed unit
mode and the unit will flash. Press [
sequence: m/s
2. Press [ WIND ] key again to return to normal mode.
Comfortable
Weak signal
km/h knots mph
Real time wind
direction indicator
Past wind
directions indicator
of last 5 minutes
Average / gust
wind speed
] or [ ] key to change the wind speed unit in this
19
Too hot
Good signal