Displaying Stored Measurements; Measuring Object Temperature - AUDIOLINE Watch&Care FS-700 Mode D'emploi

How to use

Displaying stored measurements

• Press the start button
The device switches on. After two seconds, the display shows that the
device is ready for use.
• The device automatically stores the last 32 measurements.
• Press the MEM button
The most recent measurement is displayed.
• Each additional press of the MEM button
most recent measurement. The number on the display indicates how
many measurements ago this reading was taken.
The thermometer then changes to body temperature mode after 30
seconds.
• The device only stores measurements when in body temperature
mode.

Measuring object temperature

• Press the start button
The device switches on. After two seconds, the display shows that the
device is ready for use.
The device always starts in body temperature mode
• Press the Mode button
object temperature measuring mode.
• Check the measurement ready status on the LCD.
32
or Mode button
briefly.
or Mode button
briefly. The device switches to the
briefly.
calls up the next
briefly.
.