Hayward DV4000 Mode D'emploi page 4

Installation
1. Slide the Disc onto the cleaner body insuring the side marked "UP" is up. Start one side of the Disc inner edge in the
Foot groove and pull and flex the Disc until its inner edge is fully in the groove and the Disc rotates easily. Slide the
Wear Ring onto the Foot bottom flange, insuring the stepped side is down. Flex the top edge over the flange until it is
completely above it and the Ring rotates freely.
2. Turn off your pump.
3. If connecting through your skimmer, insert the Adapter into the Skimmer outlet and the first hose through the Skimmer
inlet and its male end into the Adapter.
Page 4 of 12
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
DV4000 Rev. A