Control Panel; Operating Modes; Display Panel; Dry Mode - Danby DPA120HE3BDB-6 Manuel Du Propriétaire

OPERATING INSTRUCTIONS

CONTROL PANEL

1 2
1. Fan button: Used to set the fan speed; low,
medium, high or auto.
2. Decrease button: Used to decrease the set
temperature.
3. Increase button: Used to increase the set
temperature.
4. Mode button: Used to choose the mode; cool,
heat, fan or dry. Press and hold the mode button
for 20 seconds to change the temperature scale
between Celsius and Fahrenheit.
5. Power button: Used to turn the appliance on or
off.
Note: Certain functions can only be accessed
through the remote control.

DISPLAY PANEL

1
2
1. Temperature, time and icon display
2. Cool mode indicator
3. Temperature scale indicator
4. Timer indicator
5. Fan speed indicator
• Low fan is indicated by one bar.
• Medium fan is indicated by two bars.
• High fan is indicated by three bars.
• Auto fan speed is indicated by cycling bars.
6. Heat mode indicator
3 4 5
3
4
6 5

OPERATING MODES

Cool Mode
Choose cool mode to set the cooling function.
• Press the mode button until the snowfl ake icon
appears on the display.
• Use the increase and decrease buttons to choose
the desired temperature.
• Use the fan button to choose the desired fan
speed.
• The temperature can be set within a range of 18
- 32°C (64 - 90°F).
• The exhaust hose should be installed during cool
mode to ensure the best results.

Dry Mode

Choose dry mode to remove excess moisture from
the air during periods of high humidity.
• Press the mode button until the "dh" symbol
appears on the display.
• The fan speed will be set to auto.
• The exhaust hose should be installed during cool
mode to ensure the best results.
• It may be necessary to install the continuous
drain hose during dry mode to remove excess
water.
Fan Mode
Choose fan mode to run the internal fan without
engaging the cooling function.
• Press the mode button until the fan icon appears
on the display.
• Press the fan button to choose the desired fan
speed: low, medium or high.
• The exhaust hose does not need to be installed
during fan mode.
Heat Mode
Choose heat mode to set the heating function.
• Press the mode button until the sun icon appears
on the display.
• Use the increase and decrease buttons to choose
the desired temperature.
• Press the fan button to choose the desired fan
speed.
• The temperature can be set within a range of 13
- 27°C (55 - 81°F).
• It may be necessary to install the continuous
drain hose during heat mode to remove excess
water.
6