Arcam AVR200 Mode D'emploi page 13

TAPE MONITOR
The button selects the audio output from a
TAPE MONITOR
cassette deck connected to the
TAPE IN
AVR200. It also enables you to monitor a recording being made
on a 3-head cassette deck. Tape monitor status is shown in red
on the display.
When the tape monitor is selected, pressing other source
buttons changes the signal sent to the recorder.
NOTE: is a latching button: you will need to
TAPE MONITOR
press it again before selecting another source for listening.
CD
The button selects the source connected to the
CD
sockets.
FM, AM
To select the integrated tuner function of the AVR200, press the
or button. See the section 'Using the tuner'.
FM AM
VOLUME control
To adjust the volume level of the loudspeakers, pre-amp outputs
and headphones use the
VOLUME
shown in the display while it is being adjusted. Three seconds
after the volume is adjusted, the display reverts to show the
selected input.
Note that different sources may require different settings of the
control to achieve the same perceived volume level.
VOLUME
The volume can be controlled from 0dB over 80 steps.
BASS and TREBLE controls
Turn the bass and treble controls clockwise to boost response
or anticlockwise to cut response. For a fl at response leave the
controls in the 12 o'clock 'notched' position.
Pressing the button bypasses the bass and treble
DIRECT
controls and gives a small improvement to sound quality. If
you do not wish to alter the bass or treble controls, we
recommended that you select
DIRECT
phono sockets of the
phono
CD
control. The volume level is
.
DOLBY PL II SPEAKERS
VIDEO 1
MUSIC
after 3 seconds
DOLBY PL II SPEAKERS
VIDEO 1
MUSIC
dB
AVR200
13