Hendi 2000 Mode D'emploi page 7

Operating the appliance
• Put the plug in the socket
• Set the pan of your choice on the cooking surface, bearing the above mentioned instructions in mind.
Note! Do not leave your pan on the appliance while empty as this may lead to damage to your pan.
• Switch the appliance on by pressing the "ON/OFF key"
to activate the appliance.
If your pan is suitable for induction and has a bottom diameter of 12cm, at minimum, the appliance will go
into operation.
If you have pressed the power key
ognize this from the fact that the fan will go on and the display will show a capacity position of "100".
On the other hand, if you have pressed temperature key
operation, the default temperature is 100ºC.
Note! If the appliance beeps after being switched on, the pan you are using is not suitable for induction or the
appliance is defective. In case of any doubt, always contact the supplier of your pan!
Once the appliance is operating, it enters the Capacity mode by default, and the display indicates position
"100", you can programme the appliance in one of the following ways.
• Capacity mode: You can control the performance of the appliance, just as for a gas cooker via 11 positions
ranging from 100W to 2000W.
• Temperature mode: you can set the temperature between 35ºC and 240ºC in 5ºC increments. Standard
position for the appliance is 100ºC.
NOTE: if we keep pressing the arrow keys, the SET temperature increases in a fast speed.
Attention! The programmed temperature is that of the glass plate and not the temperature in the pan!
• Capacity mode: If you choose capacity mode, press the "Power key"
will be switched on. Default Capacity is 100W. Now you can programme the capacity required by means of
the arrow keys &
, the appliance will enter in capacity mode operation and you will rec-
, 2000W being the highest and 100W the lowest position.
and either the temperature key
, the appliance will enter in temperature mode
, the lighting of the "Power key"
or power key
EN
7