Maintenance And Cleaning - Foundations 5411339 Instructions D'installation

RECOMMENDED BLOCKING:
If the walls do not have studs on center, then additional blocking
is necessary (Fig. e).
Contact an architect or building contractor to make sure the blocking
is adequate and complies with building codes.
OPERATION:
Rotate base downward. Place infant on top of the changing surface.
Use restraint system as described below. After child has been changed,
remove restraint system and rotate base back up against the wall.
USE OF RESTRAINT SYSTEM:
Place child so restraint strap is located at abdomen. Rotate top of buckle upward and insert strap
in buckle. Pull strap through buckle until snug against infant. Rotate top of buckle downward to lock
the strap into place. Reverse steps to loosen strap.

MAINTENANCE AND CLEANING:

Check all hardware and components monthly or as required to ensure hardware is tight and there
are no missing or damaged components. Take unit out of service if any component is missing or
damaged and contact customer service to order replacement parts. Do not substitute parts.
For replacement parts, contact customer service at 1-877-716-2757.
Clean by using a damp cloth with mild soap or mild multi-purpose cleaner. Do not use any strong
chemical cleaners or cleaning agents that may be hazardous to children.
•
Child should never be left unattended.
•
Avoid serious injury from falling or sliding out. Always use restraint system.
•
Adding excessive weight such as parcels, packages, or accessories to the unit or to the bag hooks that exceed the total
weight limit of 50 pounds (22.7 kg) may cause the unit to be unstable or may cause a hazardous unstable condition to
exist.
Using Backer Plate Mounting System:
If your changing station was supplied with a backer plate, please follow these instructions. If a backer plate was not supplied and you
would like to order one, see information on page 1.
The backer plate is designed to enhance the attachment method to ensure that at least one wood stud is used to support the changing
station.
•
A stud MUST be located and used for at least one side of the diaper changing station.
• The diaper changing station is no stronger than the anchors or walls to which they are attached and, therefore, MUST be
secured in order to support the weight they are intended to support. Contact an architect or building contractor
if any questions.
•
Use backer plate mounting system with at least four (4) standard mounting screws. The backer plate alone is NOT a
secure attachment method.
1. Locate wood stud where left side of changing station will be mounted
to the wall.
2. Measure up 41 5/8 "(105 cm) from the floor and mark the wall.
NOTE: Mark on wall MUST be in center of wood stud.
3. Using two (2) 3" wood screws and a level, mount the backer plate to the
center of the wood stud (Fig. g).
NOTE: The lip of the backer plate MUST be facing away from the wall (Fig. h).
Repeat steps to secure backer plate to another stud on the opposite side.
4. Slide recessed area on back of changing station onto lip of backer plate.
5. Return to installation step 5.
For A. D. A.
Compliance
45"
(114 cm)
A. F. F
WARNING
WARNING
3
Top
8 1/4"
(210 mm)
32"
(813 mm)
on center
Fig. e
Side view of
Backer Plate
Fig. h
Fig. g