CDVI Digicode GALEOW Manuel D'installation page 17

INSTALLATION MANUAL
N
GALEOW
Illuminated keypad - Wiegand
Default values
- Illumination duration: 10 seconds,
User code lenght: 5 digits,
26 bit wiegand output,
Buzzer disabled,
Decimal mode.
Audible Signal
- 1 short beep > keypad powered
and key presses,
- 1 long beep > data computing in programming,
- 2 short beeps > Entry or Exit
from programming,
- 4 short beeps > data computing error.
A] ENTRY IN PROGRAMMING
1. Turn off the power.
Put the switch to ON.
Put back the power.
2. Two beeps are emitted to confi rm entry
in programming.
The command control of the buzzer
is not possible in programming mode.
B] ILLUMINATION DURATION
1. Enter in programming*.
2. Enter A0 to program the illumination duration :
- One beep is emitted.
- Enter the time in seconds,
10 for 10 seconds to 99 for 99 seconds
or enter 00 for a permanent illumination.
- One beep is emitted to confi rm
the illumination duration.
3. Remove the ST1 jumper :
- Two beeps are emitted to confi rm
exit from programming.
* Please refer to the procedure to start programming at the start of this section
EXE-CDVI_IM GALEOW CMYK A5 EN-FR 07.indd 17
Code Length
- In decimal mode, the user code must be in 4,
5 or 6 digits. The keypad key B is used
to validate the programming.
- In hexadecimal mode, the "A" keypad key
is forbidden.
- In ARK mode, all the selected keypad keys
are sending to the controller.
C] OUTPUT FORMAT
1. Enter in programming*.
2. Press A1 to enter in the output
format menu :
- One beep is emitted.
- Press 1 to select 26-bit wiegand output format
- Press 2 to select Standard output format
- Press 3 to select ISO Track 2 output format
- One beep is emitted to confi rm programming.
3. Remove the ST1 jumper:
- Two beeps are emitted to confi rm
exit from programming.
D] CODE LENGTH
1. Enter in programming mode*.
2. Press A2 to enter in the code length
setting menu:
A0
- One beep is emitted.
- Press 4 for a 4-digit user code, press 5
for a 5-digit user code or press 6 for a 6-digit
user code.
- One beep is emitted to confi rm programming.
3. Remove the ST1 jumper:
- Two beeps are emitted to confi rm
exit from programming.
- 4 beeps indicate a data
computing error.
EN
A1
A2
cdvi.com
17
cdvigroup.com
12/07/13 11:32