Num'axes PIE 1013 Guide D'utilisation page 43

(E = End, 88:88 = time in HH:MM).
•
You can adjust the end time from 00:00 to 23:59 by pressing the
[▲], [▼] and [M] buttons same as Start Time setting.
•
Press [M] once to save the "End Time" setting and move to the
Time Out setting. The Time Out in Time Lapse mode can be
programmed from 5 seconds (00:05) to 10 minutes (10:00) or be
set OFF. If the Time Out setting is OFF, the camera will not take
images.
•
The display
(T-O = time out, 88:88 = time in MM:SS or OFF).
•
Please complete the Time Out using the [▲],
[▼] and [M] buttons.
•
You'll then see the word "TLS" blinking on the LCD screen. Press
the DOWN [▼] button once to move to the SET menu or press
and hold the [M] button for 2 seconds to exit.
•
Now, your camera will operate in Time Lapse mode if you slide
the switch to the MAN position. The photo resolution and burst
number will be the same as in PIR detection mode.
•
To change photo resolution or burst number, please follow §
"Setting the image resolution in PIR mode" and § "Setting the
burst shoot in PIR mode".
EXAMPLES:
#1: If a user selects the Time Lapse mode, and sets the Start Time at
07:00 and End Time at 20:30, then selects the Time Out to be 3 minutes
with a Burst mode of 3 pictures, this means that the camera will take 3
pictures every 3 minutes within the time frame of 7:00AM to 8:30PM.
When not within the Time Lapse time frame, the camera will follow the
normal PIR detection settings.
#2: If a user selects the Time Lapse mode, and sets the Start Time at
08:00 and End Time at 18:00, then selects the Time Out to be OFF with
a Burst mode of 3 pictures, this means the camera will not take pictures
within the time frame of 8:00AM to 6:00PM.
Indice A
will show T-O + 88:88
43/144