Factory Default Settings; Battery And Memory Installation - Num'axes PIE 1013 Guide D'utilisation

North latitude, "-" for West longitude or South latitude.
•
time and GPS coordinates during setting or quantity of captured
image/video.

Factory Default Settings

Time Out: 30 Seconds
Burst Mode: 1 Still Image per trigger (1P)
Photo resolution: 8MP
Operation Mode: PIR
Video Mode: video length 10 Seconds - resolution 720P
Time lapse Mode setting: time frame 19:00 to 07:00 the next day, Time
out: 60 Seconds, Image resolution: 8MP, 1 Still Image per trigger (1P).

Battery and Memory Installation

Your camera is designed to operate using two different types of power
options.
NOTE: be sure the camera is in the OFF position before
inserting or removing SD card or batteries.
"AA" Batteries
The internal battery tray accepts 6 "AA" batteries. Be sure to use high
quality alkaline batteries (you can purchase NUM'AXES batteries from
NUM'AXES or from your distributor). Install the batteries with correct
polarity (+/-) as noted inside the battery tray.
Special Requirement in the use of the batteries
WARNING: Do not use batteries other than the ones
specified in this section. Doing so will damage the camera
and will void the warranty.
Do not mix old and new batteries. Do not mix alkaline,
standard or rechargeable batteries.
WARNING: ALWAYS have the camera in the OFF position
when installing or removing batteries and memory card.
Removing batteries or memory card while the camera is ON
may damage the product.
Indice A
: It indicates the date/time/time out/video recording
36/144